Many of our ram air hoods are constructed of high-strength, hand-laid fiberglass composite construction, using high quality "ISO resin" to give you the best possible quality in a fiberglass hood. Features full underside panel for complete, finished appearance. It comes with a smooth gel-coat finish, on both top and underside surfaces for easy preparation and painting.
Easily installs to factory hood hinges with no modification required. All hinge and latch mountings are reinforced with steel plates. All bolt holes are pre-drilled and tapped for easy installation. To install these hoods, all you need to do is transfer your stock hardware onto it and bolt it on to the factory hinges for final alignment.
ISO resins are a higher quality, low shrink resin that allows the part to withstand more heat and prevent distortion.
SHIPPING INFORMATION:
Hoods are shipped semi truck freight $150.00 to all lower 48 states.
PLEASE ALLOW 1-3 WEEKS TO RECEIVE YOUR HOOD DEPENDING ON YOUR LOCATION.
IF YOU ARE OUTSIDE OF THE U.S. PLEASE EMAIL US OR GIVE US A CALL FOR A SHIPPING QUOTE.
PAYMENT OPTIONS:
- Order Toll Free 7 DAYS A WEEK 9AM-11PM EST 1-866-826-1940
(ANY PROBLEMS OR QUESTIONS WITH PLACING AN ORDER FEEL FREE TO CALL US OR SEND US AN EMAIL TO HELP FURTHER ASSIST YOU )
PH: 1 (866) 826-1940 7DAYS A WEEK 9AM - 11PM EST
Email: support@xtremeautosport.net
Frequently Asked Questions
Q 1: Will water get into my intake with your ram air hood?
A. Our hoods have a built-in water management system consisting of four (4) built-in water shields to prevent water from getting in. To date, we have not had a complaint of water getting into an intake.
Q 2: Does your ram air hood system produce more HP then ram air hood with a cold air intake?
A. Yes, where you see the term "power hood" listed by the product, it means that the hood delivers air to the intake under pressure in a sealed system, which creates more HP then a cold air intake that has to suck the air into the intake. (See ram air comparsion on the side bar for more info)
Q 3: What should I do if your product comes damaged?
A. Even though we package our products very well, occasionally the freight carrier will damage our product. In that case, refuse the shipment and do not sign for it. It is expressly recommended that the package be opened and inspected immediately upon receipt, even if the box looks undamaged. CAUTION!!! If you sign off with the freight carrier on a damaged product, they will not honor any freight damage claim at a later date and you will be held responsible.
CAUTION!!! If you are having someone besides yourself receiving your package you must make it clear to them that they are not to sign off with the freight carrier until they have inspected the product and found it to be ok. If you have to refuse our product because it was damaged, simply call us and we will send you out another one ASAP. If you or someone else signs off on a damaged product, we will not be held responsible. You must refuse it!
Q 4: Should I prefit your products before I have them painted?
A. Yes, it is highly recommended that any hood be prefit before it is painted. This is especially true with fiberglass parts. If you are not the original owner it is possible that the vehicle was in a previous accident, which could effect how our product fits you vehicle.
Check out this spoiler we have for the new Ram!
Sign In
